Suspension - Control Arm and Ball Joint Assembly

On certain Tesla Model 3 and Y vehicles, the front upper right control arm can crack and separate from the steering knuckle, often without warning and under normal driving conditions. This can cause a sudden and unexpected loss of steering control. This can cause a sudden and unexpected loss of steering control. The original equipment design also uses a plastic cap over the ball joint that tends to trap moisture accumulation. That can cause an increasingly frequent creaking sound in the vehicle's front end and ultimately cause the joint to fail. This Dorman OE FIX upper front suspension control arm and ball joint assembly addresses these costly and dangerous potential failure points so vehicle owners can opt for a more permanent repair than offered by the factory design. Unlike the Tesla plastic arm assembly, our upgraded arm design prevents stress cracks and knuckle separation by utilizing a much stronger stamped steel arm. To help prevent damaging corrosion and moisture intrusion, this design eliminates the plastic cap to allow water to evaporate, and the arm is electrostatically coated. Precision engineered and manufactured to help provide many miles of reliable service, this improved control arm assembly is designed to exactly match the fit of the factory assembly, but far exceed its performance and durability.

• Upgraded design - this front upper right control arm assembly replaces the factory fiber-reinforced plastic design with an improved stamped steel design to provide greater strength and reliability than the OEM assembly
• Reduces corrosion - eliminates problematic plastic cap on factory Tesla arm that traps and holds moisture against the ball joint
• Improved coating - to further help prevent corrosion, steel arm is electrostatically coated
• Better repair - this improved control arm assembly is engineered by the aftermarket leader in suspension components to match the fit of the factory assembly but exceed OE performance and durability